Press the button to move the channel up, while pointing the remote at your SONY television.ĩ.
HOW TO GET IN THE MENU URC REMOTE CODE
Press the code numbers on the number pad of your remote.ħ. Press and hold “Mute.” Press the “Select” button until the light on your remote flashes.Ħ. Slide the switch on top of your remote control to “TV” mode.ĥ. Pick “Remote” and select the option to program it.Ĥ. Navigate to “Parental, Favs and Setup” and choose “System Setup.”ģ. The antenna should not be contacted during operation to avoid the possibility of exceeding the FCC radio frequency exposure limit.2. Antenna shall be mounted in such a manner to minimize the potential for human contact during normal operation. “CAUTION”: Exposure to Radio Frequency Radiation. The changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. Consult the dealer or experienced radio/TV technician for help. Connect the equipment into an outlet on a circuit different from that to which receiver is connected.ġ.4.
Increase the separation between the equipment and receiver.ġ.3. Reorient or relocate the receiving antenna.ġ.2. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:ġ.1. However, there is no guarantee that interference will not occur in a particular installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. Note: This equipment has been tested and found to comply with the limits for CLASS B digital device, pursuant to Part 15 of FCC Rules.
HOW TO GET IN THE MENU URC REMOTE TV
Remember, when using your remote control with a new TV or HD Set-Top Box, you may need to reprogram the remote control to operate those devices.įollow the steps included earlier in this guide to program or reprogram your remote. Press and hold the Setup button for three seconds until the Indicator LED changes from red to green.The Indicator LED will blink green twice.Press and hold the Setup button for three seconds until the Indicator LED changes from red to green.Follow the steps below to remove pairing. If you would like to use your remote control for a different set-top box, you must first un-pair the remote control from the current device. REMOVE REMOTE CONTROL PAIRING (FORCE UN-PAIR) Confirm the box is powered on and supports Device Pairing technology. Q: Why does the Indicator LED flash green then red during pairing?Ī: The device you are paring with may not be powered on, or it may not support Device Pairing technology. Once the code is correctly entered, your remote will be paired with the HD Set-Top Box connected to your TV.Follow the on-screen instructions to enter the 3-digit code that appears.If the on-screen instructions do not appear, you may need to press the Menu button again–up to two more times. Your TV should display on-screen instructions. Press the Menu button on the remote control.Press and hold the Setup button until the Indicator LED changes from red to green.
Please insure you have line of site of the HD Set-Top Box during the paring process.
0 kommentar(er)
